|Jun 14, 2019|
|3 months 4 days ||Removing some dev-specific comments (since this commented out code
has now been committed to dev)
|3 months 4 days ||Porting the restructuring of the technical snow from trunk (it is
now somehow like in a separet TechSnow module, see commit 1763). The
densification bug fixed by commit 1764 is also fixed here (so it is
perfectly in sync with trunk).
|3 months 5 days ||A small bug has been fixed (inconsistent thresholds in the
densification equation) and some documentation added to the
|Jun 13, 2019|
|3 months 6 days ||Restructured version of the technical snow in order to make it a
|Jun 12, 2019|
|3 months 6 days ||One part of the techSnow backport was missing...
|3 months 6 days ||Backporting the technical snow code from dev.
|3 months 7 days ||Added the Canopy output in SMET time series
|May 30, 2019|
|3 months 19 days ||Taking care of the case where the chosen time step is smaller than,
or equal to, 60 seconds, in which case adaptive time stepping should
not be active.
|3 months 20 days ||Making it default to redo the heat equation with a smaller time step
upon non-convergence, and use the key ALLOW_ADAPTIVE_TIMESTEPPING
exclusively to prematurely reduce the time step to reduce spurious
oscillations near the surface. So setting ALLOW…
|May 28, 2019|
|3 months 21 days ||For sea ice module: tracking total flooding when using the Bucket
|Apr 16, 2019|
|5 months 2 days ||LEHNING_1 albedo could run into a floating point exception in very
wet conditions, due to Alb1 < -1.
|5 months 2 days ||Typo.
|Apr 15, 2019|
|5 months 3 days ||Improving consistency in dealing with rounding errors in phase
|Apr 12, 2019|
|5 months 7 days ||Adding the missing case of mk 9 for a water layer. Note that
otherwise, a<0, such that the cast to unsigned short int
experiences an underflow and type >> 1000.
|5 months 7 days ||Improving documentation.
|Apr 9, 2019|
|5 months 10 days ||Setting initial snow salinity to 0 and disable the zero flux upper
boundary condition for advection. Both modifications are for
numerical stability, but it is not the desired setting for the model.
|5 months 10 days ||Adding comments to understand the function call.
|5 months 10 days ||Introducing stricter limits on the van Genuchten parameters for sea
ice, for the sake of numerical stability. Additionally removing some
|5 months 10 days ||Sea ice: introducing special condition to favour only evaporation,
not necessarily condensation when solving richards equation, to
|5 months 10 days ||For sea ice: when mass is removed from the domain, adjust the
pressure head in saturated conditions, to reflect the new pressure