|Apr 15, 2017|
|3 years 2 months ||Small bug fix, to make valgrind more happy.
|3 years 2 months ||Removing unused functionality from Richards solver.
|3 years 2 months ||Improving the code regarding setting the hydraulic conductivity of
the matrix and preferential flow domain. Also making a warning
message only appear once during a simulation.
|3 years 2 months ||Forgot to set the lower boundary condition (a no flux one) for the
vapour flux. Should make valgrind happy again!
|Apr 13, 2017|
|3 years 3 months ||Merging dev-branch up to and including rev. 1344 into the
|3 years 3 months ||Introducing vapour transport in SNOWPACK, developed by Margaux
Couttet. Disabled by default, enable by setting:
"ENABLE_VAPOUR_TRANSPORT = TRUE" in the [SnowpackAdvanced]
section. It also separates the treatment of evaporation
|3 years 3 months ||Nander found (and fixed) a bug when handling the measured albedo
that could lead to negative albedo (nodata+valid albedo)
|Apr 12, 2017|
|3 years 3 months ||Unfortunately, a very severe memory management bug was found. It is
now fixed but this means that the last release is impacted...
|Apr 10, 2017|
|3 years 3 months ||Setting Canopy direct throughfall to 1 was leading to a floating
point exception. Now a check is performed and an explicit exception
is thrown instead.
|Apr 6, 2017|
|3 years 3 months ||Dealing with stability issues in vapour transport: limit the amount
of mass change to the amount of mass available. This needs further
improvement soon. Also the new phase change method is switched off.
This behaves more stable and the sea ice versio
|Apr 5, 2017|
|3 years 3 months ||An else condition went missing when redesigining soil evaporation.
Was this on purpose? In any case, it lead to small mass balance
problems with Richards equation, but the why and how questions, I
|Apr 4, 2017|
|3 years 3 months ||Removing an unused variable, that was actually potentially referring
out of array bounds, as indicated by valgrind.
|3 years 3 months ||Merging dev-branch up to and including rev. 1336 into the
|3 years 3 months ||Better and more consistent treatment of ice layers throughout the
code, with a single place to control the maximum amount of
|Apr 3, 2017|
|3 years 3 months ||A default case for Bdata.qg is required for valid simulation setups
without a provided geo_heat.
|3 years 3 months ||Merging dev-branch up to and including rev. 1333 into the
|3 years 3 months ||Small correction of previous commit.
|3 years 3 months ||Introducing the possibility to reference the snow height
measurements for the snow height driven mode to an arbitrary
reference level inside the model domain, by marking the specific
layer in the sno-file with marker int(mk/1000)==9, for example 900
|3 years 3 months ||Merging dev-branch up to and including rev. 1330 into the
|3 years 3 months ||Introducing the possibility to use a prescribed and time varying
GEO_HEAT from a mio::MeteoData object, for example, a SMET file.